Manual AC hose crimper kit, hydraulic hose crimping tool for auto ac system

AC hose crimping tool, Manual Hydraulic AC Hose Crimper    

Pre-operation set-up
Open the relief  valve to fully recess the piston.Then,close tightly.
Rotate the yoke fully counter clockwise to bottom out the adapter seat.

Operating Instructions
1. Remove pin and open top york

2. Select correct die set

3. Insert dies into yoke

4. Position fitting and hose in crimper and close top yoke

Note: Be sure to use correct die set! Failure to do so could cause leakage or failure in the crimp.

5. Insert pin securely

Note: Make sure pin set securely insert into space before crimping process is started.

6. Turn body of tool clockwise until dies are snug against hose fitting.

7. Turn hydraulic valve to closed position.

8. Pump handle to crimp fitting onto hose. Continue pumping until handle comes to a stop.

Note: Place the body of the tool against a solid body to create more leverage during the crimping process.

9. Once crimp is complete, turn hydraulic valve to OPEN position.

10. Turn body of tool counter clockwise until top yoke can be rotated away from piston portion of yoke.

11. Remove holding pin and open yoke.

12. Remove hose assembly.

Features: 
dies snap quickl into place requiring no pins or screws
Unit can be easily mounted to a bench using the holding fixture (included) or a vice

Includes:
Hydraulic A/C Hose Crimper kit is applicable for beadlocking fitting.The tool includes seven
sets of dies for barrier a/c hose.The crimping tool has a base that can be mounted to a bench
for easy use ,or the base can be held by any vise

Packing of Manifold Gauge, Auto Air Condition Tool
A) Sturdy tool kit
B) nutral carton box
C) ACTECmax mark or according to client's order